[Gavril G2R interior with separate seats]

wEiGhT rEdUcTiOn BrO!

Instructions for installation:

1.) Drag all three mesh files into your G2R's zip file.

2.) Open your truck file and press "ctrl + F" and search for the "flexbodies" section.

3.) Copy and paste the lines you want into the flexbodies section.

11,12,3, -0.165, 0.5, -0.21, 0.0, 90.0, 0.0, G2R_FLseat.mesh
forset 0-79,92-99,134-141,172-179,194-197,200-203

11,12,3, -0.165, 0.5, -0.21, 0.0, 90.0, 0.0, G2R_FRseat.mesh
forset 0-79,92-99,134-141,172-179,194-197,200-203

11,12,3, -0.165, 0.5, -0.21, 0.0, 90.0, 0.0, G2R_Rseat.mesh
forset 0-79,92-99,134-141,172-179,194-197,200-203

If you want to keep the front seats but not the rear seats, copy in all those lines 
except the last one.
If you want to keep only the driver's seat, only copy the line for "G2R_FLseat.mesh"
If you want NO seats and either want to put in your own seats or be a madman and drive
without a seat, DON'T put in any of those lines.
If you want to keep ALL seats (why would you do that tho?), then put in ALL of those 
lines.

Don't worry about the existing seats. When you put in the gavrilinterior_r.mesh from 
this zip into your car's zip, it should have replaced the original. This one, of course, 
has no seats.